RIDGID HD16100 Manual Del Usuario página 6

ASSEMBLY
Caster/Caster Foot Assembly
NOTE: Remove Powerhead Assembly
from Dust Drum prior to assembly of
Casters and Caster Feet.
1. Turn Dust Drum upside down on floor.
2. Place Caster Foot on floor. Insert the
stem of a Caster into socket of Caster
Foot.
3. Push on the Caster until the Caster ball
end snaps fully into the Socket and the
Caster swivel freely. Repeat for other
three Casters and Caster Feet.
4. Place Caster Foot with Caster over
post on bottom of Dust Drum and press
firmly in place, as shown.
5. Repeat for the other three Caster/
Caster Foot assemblies.
6. Turn the Dust Drum upright.
Post
Dust
Drum
Caster
Caster Stem
Caster Ball
Caster
Foot
Caster Foot
Caster Foot
Post Hole
6
Wet/Dry Vac Assembly
Attaching / Removing
Powerhead Assembly to
Dust Drum
1. Place Powerhead Assembly on top of
Dust Drum with the Extended Lip of the
Powerhead Assembly aligned with the
Inlet. Be sure Powerhead Assembly is
fully seated on the Dust Drum.
Powerhead
Assembly
Extended
Lip
Dust
Drum
Vac Inlet