Thermador T18ID905LP Manual De Uso Y Cuidado página 23

DCleaning
9
CAUTION
C l e a n i n g
AVOID DAMAGING THE APPLIANCE AND THE
EQUIPMENT.
Do not use abrasive, chloride-based or acidic
■
cleaning agents or solvents.
Do not use scouring or abrasive sponges.
■
The metallic surfaces may corrode.
Never clean the shelves or bins in the
■
dishwasher.
The parts may become deformed.
Proceed as follows:
Press the main On/Off switch.
1.
Take out food and store in a cool location.
2.
Place ice pack (if available) on the food.
Clean the appliance with a soft cloth, lukewarm
3.
water and a little pH-neutral washing-up liquid.
9
CAUTION
The rinsing water must not run into the light
or through the drainage hole into the
evaporation area.
Wipe door seal with clear water and dry
4.
thoroughly with a cloth.
Switch appliance back on and put in food.
5.
Care instructions for stainless steel
surfaces
When taking care of and cleaning stainless steel
surfaces, use only cleaning agents suitable for
stainless steel and a stainless steel cleaning cloth.
You can purchase a suitable stainless steel cleaning
cloth from customer service.
To prevent visible scratches, clean the stainless
steel surface in the direction of the structure.
Cleaning the display
The change in temperature and humidity can cause
the controls to steam up.
Switch the clean lock on before cleaning.
~ "Clean lock" on page 14
Use a clean micro-fiber cloth for cleaning.
Cleaning the equipment
To clean, take the removable parts out of the
appliance.
~ "Equipment" on page 11
Ice cube container
9
CAUTION
A full ice cube container is heavy:
■
Pull the container out with both hands.
Risk of cold burns:
■
Avoid prolonged contact of the skin with
frozen food, ice and metal surfaces in the
freezer compartment.
To ensure you always have fresh ice cubes and to
prevent old ones from sticking together, remove
them and clean the ice cube container regularly.
Lift the ice cube container.
1.
Slowly pull out the ice cube container.
2.
Empty and clean the ice cube container with
3.
lukewarm water.
Dry the inside of the ice cube container off well so
4.
new ice cubes do not freeze and stick to it.
Insert the ice cube container until it engages.
5.
If the ice cube container cannot be inserted,
Note:
rotate the conveyor and try again.
Cleaning en-us
23