Futurelight PRH-540-2 Manual Del Usuario página 29

INSTALLATION
Rigging
Please consider the EN 60598-2-17 and the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
Before installing a device on the FUTURELIGHT PRH-540-2, make sure it is applicable
for the desired mounting method! Always follow the instructions in the user manual
and secure the device via the FUTURELIGHT PRH-540-2's fixation points!
The installation of the rotating holder has to be built and constructed in a way that it can hold 10 times the
weight for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Only install devices on the FUTURELIGHT PRH-540-2 with an appropriate safety fixture!
Attach safety-ropes via safety-eyelets or brackets with self-locking nuts!
For overhead rigging, always mount the FUTURELIGHT PRH-540-2 to the trussing system
Procedure:
The rotating holder should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the rotating holder. If you lack these qualifications, do not attempt the installation
yourself, but instead use a professional structural rigger. Improper installation can result in bodily injury
and.or damage to property.
The device has to be installed out of the reach of people.
If the rotating holder shall be lowered from the ceiling or high joists, professional trussing systems have to be
used. The rotating holder must never be fixed swinging freely in the room.
DANGER TO LIFE!
CAUTION!
CAUTION!
CAUTION!
first - please see section Rigging.
29/83 51837615_V_1_1.DOC