Control Function; Network - Pioneer MCS-838 Manual De Instrucciones

Control function

Problem Check
Control function does not Is the HDMI cable properly
work. connected?
Is the HDMI cable you are
using a High Speed HDMI
Cable?
Is this player connected to the
TV using an HDMI cable to
watch the picture?
Does the connected device
support the Control function?
Is Control set to On on the
connected device?

Network

Problem Check
BD-LIVE function
(connection to the
Internet) cannot be
used.
"No valid id file found!"
is displayed when I try
to update the software.
Software updating is slow.
A message other than Is "Network is FAILED."
"Networks is OK." displayed?
is displayed when
Connection Test is
performed.
Is the Ethernet hub (or router
with a hub functionality)
operating properly?
Cannot access to the Internet security software
component or computer is currently installed in the
connected via network. connected component.
The audio component on
the network which has been
switched off is switched on.
Remedy
To use the Control function, connect the Flat Screen TV to the HDMI
OUT terminal (page 35).
Use a High Speed HDMI
®
/™ properly if an HDMI cable other than a High Speed HDMI
used.
If video signals are being output from a terminal other than the HDMI
OUT terminal, the Control function does not work. Connect to the TV
using an HDMI cable (page 35).
The Control function will not work with devices of other brands that
do not support the Control function, even when connected using an
HDMI cable.
The Control function will not work if devices that do not support the
Control function are connected between the Control-compatible
device and the player.
See page 16.
Even when connected to a Pioneer product compatible with the
Control function, some of the functions may not work.
Also refer to the operating instructions for the connected device.
Set Control to On on the connected device. The Control function
operates when Control is set to On for all devices connected to the
HDMI OUT terminal.
Once connections and settings of all the devices are finished, be sure
to check that the player's picture is output to the Flat Screen TV. (Also,
check after changing the connected devices and connecting and/or
disconnecting HDMI cables.) If the player's picture is not being output
to the Flat Screen TV, the Control function may not work properly.
For details, refer to the operating instructions of the connected device.
Remedy
Perform Connection Test (page 78). If "Networks is OK." is displayed,
check the proxy server settings (page 78). Also, there may be a problem
with the Internet connection. Contact your Internet service provider.
Depending on the Internet connection and other conditions, some time
may be required to update the software.
Check that this player and the Ethernet hub (or router with a hub
functionality) are properly connected.
If the IP address is obtained using the DHCP server function, check
the setting is correct at the Information (page 75). For details on the
DHCP server function, see the operating instructions for the Ethernet
hub (or router with a hub functionality).
Set the IP address manually.
Check the operation and settings of the DHCP server function of the
Ethernet hub (or router with hub functionality). For details on the
DHCP server function, see the operating instructions for the Ethernet
hub (or router with a hub functionality).
If this player has been set manually, reset the IP address of this player
or other components.
Check the settings and operation the Ethernet hub (or router with a
hub functionality). For details, see the operating instructions for the
Ethernet hub.
Reboot the Ethernet hub (or router with a hub functionality).
There are cases where a component with Internet security software
installed cannot be accessed.
Switch on the audio component on the network before switching on
this unit.
Troubleshooting
®
/™ Cable. The Control function may not work
85
En
®
/™ Cable is
9