Waeco ASC 5500G RPA Instrucciones De Uso página 125

Idiomas disponibles

ASC5500G RPA

Changing the vacuum pump oil

Switch off the AirConServiceCenter and unplug it from the power

supply before opening the housing.

1. Before changing the oil, let the vacuum pump run for about 10 min-

utes (manually, via the menu).

The following steps may only be performed by qualified personnel.

2. Take off the front panel:

Undo the screws (D) on the control panel and lift it up. Then undo the

screws (E) on the bottom of the front panel and take it off.

3. Place a receptacle with a capacity of at least ½ litre under the

AirConServiceCenter. The oil from the vacuum pump flows through

the opening (I) in the base of the unit.

Service tasks