Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1-2
The charger base, shrink tubes and screws are provided
with the vacuum cleaner.
4. Align the ribs of the charger (2) to the ribs of the charger
base (1), then push the charger (2) into place. When you
here a click, the charger (2) is installed.
7.1.1.2 REMOVE THE CHARGER
1. Press the base release button (3), and remove the charger
from the charger base (1).
English
1-1
NOTE
7.1.2
STAND CHARGER BASE
7.1.2.1 INSTALL THE CHARGER
1. Align the hole on the rod with the release button on the
bottom base, and insert the rod (4-1) to the bottom base
(4-2).
2. Align the release button on the charger base with the hole
on the rod, and insert the charger base (4-3) into the rod
(4-1).
6
4-1
4-2
Publicidad
