Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. Connect the other end of the power cord (8) to the
charging port (7) on the charger.
For the stand charger base, align the power cord into the
groove in the rod.
3. Lift and hang your machine (10) with the battery pack
(12) onto the port (11), or
remove the battery pack (12) from the machine, then
insert the battery pack (12) into the rapid charging port
(13).
English
NOTE
If you charge the batteries in both port (11) and port
(13), the battery in port (11) won't be charged until the
battery in port (13) is full charged.
This is a diagnostic charger. The Charger LED Screen (14)
shows the current battery status. They are as follows:
1.
BATTERY CAPACITY LIGHT (STANDARD
CHARGING)
2.
BATTERY CAPACITY LIGHT (RAPID CHARG-
ING)
3.
CHARGING TIME LEFT (RAPID CHARGING)
4.
ERROR or OVER-TEMPERATURE WARNING
STANDARD CHARGING
(PORT(11))
BATTERY IS CHARGING
FULLY CHARGED
BATTERY IS TOO WARM (RE-
MOVE FOR APPROX. 30 MINUTES
TO ALLOW TO COOL)
8
NOTE
GREEN
BLINKING
SOLID
GREEN
RED
Publicidad
