Fault
A warning tone
sounds, the temperat-
ure display (freezer
compartment) flashes,
appears and
the status display
lights up red.
The set temperature is
not reached.
Fully automatic de-
frosting no longer
works.
Cause and troubleshooting
Different causes are possible.
Press
.
▶
a The temperature display (freezer compartment)
briefly indicates the warmest temperature reached
in the freezer compartment. The temperature dis-
play (freezer compartment) then indicates the set
temperature again.
a The alarm is switched off.
lights up until the set temperature is
a
reached.
The appliance door is open.
Close the appliance door.
▶
Larger quantities of fresh food have been put in.
Do not exceed the max. freezing capacity.
▶
→ "Freezing capacity", Page 51
The freezer compartment door was open for a long
time. The evaporator (refrigeration unit) in the noFrost
system is heavily iced up.
Requirement: Store the frozen food well insulated in a
cool place.
Switch off the appliance. → Page 48
1.
Disconnect the appliance from the mains.
2.
Unplug the appliance from the mains or switch off
the circuit breaker in the fuse box.
Move the appliance away from the wall.
3.
Leave the appliance door open.
4.
a After approx. 20 minutes, the condensation starts to
run into the evaporation pan at the rear of the appli-
ance.
→ Fig.
27
To prevent the evaporation pan from overflowing,
5.
mop up the condensation water with a sponge.
The evaporator is defrosted if no more condensa-
tion water runs into the evaporation pan.
Clean the interior of the appliance. → Page 54
6.
Switch the appliance back on. → Page 47
7.
Troubleshooting en
57