Oregon Scientific BAR688HG Manual Del Usuario página 7

SENSOR DATA TRANSMISSION
The sensor reception icon in the remote sensor area
shows the status.
ICON
and "- - . -"
(Outdoor
temperature Area)
To search for a sensor:
Simultaneously, press and hold MEM and CHANNEL
for 2 seconds.
NOTE If the sensor is still not found, check the batteries,
obstructions, and remote unit location.
CLOCK
CLOCK RECEPTION
This product is designed to synchronize its date and time
automatically once it is within range of :
DCF-77 generated from Frankfurt, Germany for
•
Central Europe.
MSF-60 generated from Anthorn, England.
•
P/N:086L004344-058 REV 1
7/94
DESCRIPTION
Main unit is searching
for the sensor(s)
A channel has been found
and sensor signal is being
received
The sensor cannot be found.
Search for the sensor or
check batteries
The clock collects the radio signals whenever it is within
1500 km (932 miles) of a signal.
NOTE Slide the EU / UK switch to appropriate position for
your location. Repeat each time you reset the unit.
NOTE Initial reception takes 2-10 minutes for first set
up or when RESET is pressed. Once complete, the
reception icon will stop blinking. If the signal is weak, it
can take up to 24 hours to get a valid signal.
RECEPTION SIGNAL
Clock signal reception indicator:
STRONG SIGNAL
To enable and force a signal search:
Press and hold for 2 seconds.
To disable the signal reception:
Press and hold for 2 seconds.
SET CLOCK
If the clock signal reception is enabled and a signal is
being received the clock does not need to be manually
set.
1. Press and hold MODE for 2 seconds.
2. Press or to change the settings.
6
WEAK SIGNAL NO SIGNAL