Skymsen LAR-04MB-HD Manual De Instrucciones página 12

Sound Pressure:
• Value ± 3 dB
• It is compared with an essentially free field over a
reflecting plane. In accordance to ISO 3744.
• Jug with a 25% capacity filled with water.
2. Installation and Pre-Operation
2.1 Installation
2.1.1 Positioning
Your appliance must be positioned and leveled on a dry and
firm surface with 850 mm of height.
2.1.2 Electrical Installation
Before stating the machine, check the voltage on the label
existent on the cord.
When you receive the equipment check the voltage
indicated on the cord label. The power plug has 2 (two) pins
and a hole is for the grounding. It´s mandatory that all three
spots are properly connected.
grounding
hole
pine
Make sure the network voltage is the same as
indicated on the cord label.
12
CHARACTERISTICS
Jug Capacity
Rotation
Voltage
Frequency
Motor Power
Height
Width
Depth
Net Weight
Gross Weight
Sound Power dB (A)
Sound Pressure dB (A)
PICTURE 03
850 mm
PICTURE 04
CHART 01
UNIT LAR-04MB-HD LAR-08MB-HD
l 04
rpm 3500
V 230
Hz 50
kW 0,66
mm 660
mm 290
mm 280
kg 10,5
kg 11,5
79,68
69,80
The protection device against overcurrent will work at 7,5
amps.
2.2 Pre-Operation
2.2.1 Jug Positioning
The Jug has a versatile fitting system that enables it to be
fitted in very safe and simple way.
To remove the Jug just pull it up with the handle. Always
remove or reposition the Jug holding the handles firmly.
2.2.2 Placing the Lid
The Jug Lid was developed with non-toxic rubber and
provides efficient sealing during process.
The sensor monitors the lid, and this sensor must be
aligned in the correct position to allow the Blender to work
normally, see Picture 6. For safety reasons, if the lid is out of
position, the machine won´t work.
Do not open the lid when the machine is working. In this
case, start again item 3.1.
LAR-10MB-HD
08 10
3500 3500
230 230
50 50
0,66 0,66
750 780
330 340
320 330
11,1 11,3
12,2 12,5
79,68 79,68
69,80 69,80
PICTURE 05
Never remove or position
the Jug if the appliance is on.