Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting and disconnecting (Portable models only)
Connect the Unicouple to the Faucet (Portable Models Only)
Run garbage disposer, if you have one, to clean out
the disposer and thus allow water to drain from the
sink through the disposer and down the drain.
Run hot water faucet to purge cold water from the hot
water line. The hot water must be between 120°F and
150°F for best wash performance.
Roll the dishwasher to a position just in front of the
sink.
Pull the unicouple and its hoses completely out from
storage compartment at rear of the dishwasher.
Attach the unicouple to the faucet adapter following the
three steps below:
- Depress the locking collar at the top of the unicouple.
- Place the unicouple completely over the faucet
adapter.
- Release the locking collar. The unicouple should now
be locked onto the faucet adapter.
Disconnect and Store Your Dishwasher (Portable Models Only)
Remove Power
Unplug the dishwasher.
Feed power cord back into its storage location.
Remove Unicouple from Faucet
Turn off hot water.
Relieve water pressure from the unicouple assembly
before disconnecting it from the faucet by depressing
the red pressure relief button on the unicouple.
Depress red button to
release water pressure
Depress the locking collar and remove the unicouple
from the faucet.
Depress collar to
release unicouple
from faucet
12
NOTE: The unicouple's small hose carries water from
the faucet to the dishwasher. The large hose carries
water from the dishwasher to the sink. Orient the faucet
with the unicouple attached so water from the unicouple
will run into the sink drain.
Collar
Store the Dishwasher
Turn on the hot water faucet and check for leaks. If a
unicouple leak was observed, take whatever actions
are necessary to repair the leak. This may be as
simple as tightening the faucet adapter. Or, it may
require the services of a plumber if water is leaking
from the interface between the moveable faucet arm
and the fixed part of the faucet fastened to the sink.
Plug the dishwasher power cord into the electrical
outlet.
Drain excess water from the unicouple. If the sink is 34"
or higher from the floor, the excess water in unicouple
hoses cannot be drained directly into the sink. It will be
necessary to drain excess water from hoses into a bowl
or suitable container that is held outside and lower than
the sink.
Feed the unicouple and hoses back into their storage
pocket.
Latch the dishwasher door closed.
Roll the dishwasher into its storage location.
49-4000275 Rev 1
Publicidad
