Error Messages - Brother PE-700II Manual De Instrucciones

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e Select the pattern you wish to retrieve.
Switch screens using
and (Next page key).
b
a
a Total amount of memory used
b Total amount of memory space
c Number of the currently displayed page from the total
number of pages
The selected pattern is shown in reverse
highlighting.
f Press .
The saved pattern is retrieved.
The embroidery screen appears, and you
can embroider the retrieved pattern.

Error messages

Memo
This manual describes the error messages concerning the USB connection. For details on other error
messages, refer to the Operation Manual.
Error Message
4
g
(Previous page key)
c
While embroidering, data is written to the "Removable Disk" in the
connected computer or data is deleted from the "Removable Disk".
When 13 or more patterns are in "Removable Disk", a pattern was
being retrieved.
Retrieving the pattern
Transmitting by USB
Adjust the pattern as desired, and then begin
embroidering.
Note
If there are 13 or more patterns saved in
"Removable Disk", the patterns cannot be
displayed. When the message "Reduce the
number of patterns. Only up to 12 patterns
can be handled." appears, delete patterns
from "Removable Disk" so that it contains
no more than 12 patterns. Then, close the
error message, repeat the procedure starting
d
from step and then press
the pattern.
If patterns copied to "Removable Disk" are
not saved in the machine's memory, their
data is lost when the machine is turned off.
In order to retrieving patterns directly from
the machine the next time that they are
needed, save the data in the machine's
memory before turning off the machine. For
details, refer to "Storing patterns" of the
Operation Manual.
Probable Cause
to retrieve