Publicidad
Idiomas disponibles
Idiomas disponibles
TOOLS
1
Thrust sleeve
2
Thrust disc
3
Spindle
4
Retaining claw
5
Bridge
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This tool set is made to install the bush in the rear trailing arm. The tool set is suitable for Honda Civic
(1988-2000), Del-Sol (1993-1997), CRV (1997-2002) and Acura Integra (1994-2001).
SAFETY INFORMATIONS
• Read carefully the instructions before working with this tool set.
• Do not use this tool set for other purpose for which it is designed.
• Lifting of vehicles only allowed on the special lifting points.
• Before starting work under a car always ensure that it is adequately supported by axle stands or
ramps. Chock wheels and ensure that the hand brake is firmly applied.
• Always use approved eye protection, especially when working under vehicles.
• Ensure that tools are correctly mounted.
• Do not over tighten or use undue force as this can cause damage to both tool and component.
• The tool is not suitable for air impact wrenches. The use of an air impact wrench may lead to
the spindle bearing or other components bursting and fragments of components flying around
may lead to injuries.
• Always use workshop manual for detailed instructions.
• Always lubricate the screw threads before using the tool.
• Check & replace any damaged components as required.
• Keep children and unauthorized persons out of the working area.
• Keep this tool out of children reach.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Trailing Arm Bush Tool | for Honda
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 6890
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
