BGS technic 6890 Manual De Instrucciones página 4

USE
The tool is suitable for the illustrated bushing in
the trailing arm.
Slide the thrust sleeve (1) over the O-ring onto
the thrust disc (2).
After the thrust sleeve (1) is mounted, it is held
by the O-ring on the thrust disc (2).
When aligning the retaining claws (4), make
sure that both claw arms are aligned with the
same distance to the center on the bridge (5)
(see scale on the bridge).
Position the trailing arm bush (B) in the thrust
sleeve.
Position the retaining claws (4) behind the
trailing arm (A).
Preload tool as shown.
Check the fit of all tool parts.
Press the bush into the trailing arm (A) by
turning the spindle (3) clockwise.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed