Finishing The Thread Ends; Bobbin Work Free-Motion Sewing - Brother Innov-is 4750D Manual De Instrucciones

q
Leaving about 10 cm (approx. 4 inches) of
thread at the ends, use scissors to cut the
threads.
a 10 cm (approx. 4 inches)
Note
• Do not sew reinforcement/reverse stitches or use a
"Thread Cutter" button (if so equipped) at the end of
the stitching; otherwise it will be difficult to pull the
bobbin thread up to the wrong side of the fabric. In
addition the threads may become tangled or the
needle may break possibly causing machine
damage.

Finishing the Thread Ends

a
At the end of the stitching, pull the end of the
bobbin thread up to the wrong side of the
fabric.
a
Wrong side of fabric
b
Bobbin thread
Note
• If it is difficult to pull up the bobbin thread, use a
ribbon embroidery needle to pull the thread up to the
wrong side of the fabric. Otherwise, use an awl to
pull up the bobbin thread.
10
b
From the wrong side of the fabric, tie the
bobbin thread and the upper thread together
by hand, and then cut off excess threads with
scissors.
a
Wrong side of fabric
b
Surface of fabric
Note
• To ensure threads do not come undone after being
tied place a drop of fabric glue on knots.
c
If the desired results could not be achieved,
adjust the tension of the bobbin thread and of
the upper thread, and then try sewing the
stitching again.
For more details, refer to see "Adjusting the
Thread Tension" on page 11.

Bobbin Work Free-Motion Sewing

Note
• For bobbin work free motion sewing use the
instructions for "Creating Bobbin Work" beginning on
page 8.
• Use the quilting foot provided with your machine. If
you do not have a quilting foot, contact your nearest
authorized dealer to purchase. For details on using
the quilting foot, refer to the Operation Manual
provided with your machine or with the presser foot.
If so desired, use a template or draw your design on the
stabilizer to allow for ease of stitching. Remember, your
stitches with your decorative thread will be on the
underneath side of your fabric and the stabilizer will be
on the top of the wrong side of your fabric.
a
Print the desired template.
Note
• Print the template in its original dimensions. If an
enlarged template is used, the bobbin thread may
run out during sewing.