Introduction; Description - Chauvin Arnoux Y2N Manual De Instrucciones

The Y2N 1000:1 current clamp is designed for alternating current measurements in low-voltampere
systems, from 4 A to 500 A AC (up to 600 A AC max - see § 4.3.1).
The asymmetrically shaped jaws clamp around cables or busbars.
The Y2N connects to any multimeter, recorder, etc. having an alternating-current input with an
impedance of ≤10 Ω or less.
It features dual or reinforced insulation and conforms to international standards, such as IEC 1010-2-032
"Current clamps" (see § 4.4).
(See drawing § 7. Appendix )
Overall dimensions: 195 x 66 x 34 mm
Weight: 420 g
➀
Jaw opening: 33 mm
Height with jaws open: 96 mm
➁
4 centring marks
Max clamping capacity: 30 mm dia. cable and 63 x 5 mm busbar
➂
I arrow indicating the direction of current flow. The current is considered to flow in the positive
direction when flowing from the "current producer" to the "current consumer". This orientation of the
current clamp is required during a power measurement (current measured concurrently with
voltage).
Cable length: 1,5 m
Output via two 4 mm dia. safety elbow plugs.

1. INTRODUCTION

2. DESCRIPTION

12