TREVIDEA GIRMI GT02 Manual Del Uso página 12

ASSEMBLING AND OPERATING
- Insert the roller (8 or 9) inside the housing, pressing the unlock button on the roller (4) and pushing until it
snaps. Use the roller for fine grating (8) to grate the cheese and coarse one (9) to make vegetables julienne,
chocolate pieces or more coarsely cheese.
- Release the button to lock / unlock the roller (4) and check that it is inserted correctly.
- Insert the battery already charged into the battery compartment (7) in the back of the unit, aligning the pin
(E) with the track (6) and pushing inside the battery until it snaps.
- Now the cheese grater is ready for use: lift the food-pressing cover (1), insert the cheese or food you want
to grate, close the cover and push the food against the roller.
CHARGING
CAUTION: only use the original power supply adapter (A) to recharge the unit.
If the charger gets lost or damaged, contact an authorized service and do not use other adapters that may
seriously damage the internal battery and jeopardize the functionality of the appliance. Charging must be
done when the product loses power and efficiency during grating operations.
To recharge the unit, remove the battery pack (D) from the bottom of the unit and place it in the battery
compartment (B) of the charging base (A)
Connect the power adapter (A) to the electrical outlet.
The LED charging indicator (C) lights up when:
- The battery is connected to charging base. To see if battery is properly connected.
- The power plug is connected to power supply
The maximum charging time is about 4-5 hours.
When charging is finished, remove the battery pack from its charging compartment and insert it again into the
battery compartment placed at the bottom of the unit.
The following measures will preserve battery life.
When you first use the unit, fully charge the battery by leaving it connected to the adapter for about 4 hours.
Before you recharge, ensure the battery is fully exhausted.
For at least 2 times a year, fully discharge the battery and then recharge it for 4 hours.
When you're going not to use the unit for a long time (i.e. 2 months), it is recommended to charge the battery
for about 4 hours before using it again.
If the battery life seems to lower after several use, it is recommended to let the grater on until the battery is
completely exhausted. At this point, charge it for 4 hours.
If the problem persists, the battery could be no longer capable of supplying power to the unit. In this case,
contact an authorized service center to buy a new battery pack.
CLEANING AND MAINTENANCE
Take out the battery pack and unplug the power adapter before starting any cleaning operations.
CAUTION: Handle rollers with care to avoid the risk of cutting himself.
- The rollers can be treated as normal dishes. Wash them under the jet of tap water. For a more accurate
cleaning, use a soft sponge and dishwashing detergents.
- Always remove the remaining grated chase by using a cloth or sponge.
- Do not immerse the appliance in water or other liquids. Use a damp cloth to cleaning the unit.
TECHNICAL FEATURES
•
Adapter power supply: IN AC 230V
•
Roller-lock system
•
Accessories: 2 rollers, for fine and coarse grating
•
Charging pack: battery unit, AC/DC power adapter with charging base
50Hz – OUT DC 5V – 300mA
~
11