Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Switch
Housing
Step 1. Remove the 1 of 3 screws from the
mounting plate and keep it for future use.
Loosen the other 2 screws. (Do not remove)
Step 2. Snap the wire connection plugs
together.
Step 3. Place the key holes on the switch
housing over the 2 screws previously loosened
from the mounting plate, turn switch housing
until it locks in place at the narrow section of
the key holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Figure 14)
Connection
plugs
Switch housing
Figure 14
Mounting plate
Screws
8.
Publicidad
