Getting started
Calling the wake-up timer
An existing timer setting can be reused.
1
Follow steps 1 to 3 in "Setting the wake-up
timer".
2
Press
to select "TIMER ON", then press
ENTER.
Cancelling the wake-up timer
Turn off the timer setting.
1
Follow steps 1 to 3 in "Setting the wake-up
timer".
2
Press
to select "TIMER OFF", then
press ENTER.
Using the wake-up timer
1
Press
STANDBY/ON to turn the power
off.
2
At the wake-up time, this unit will turn on
automatically and play the selected input
function.
Note
• If at the wake-up time an iPod/iPhone/iPad is not
connected to the unit or a disc is not inserted, the unit
will be turned on but will not play back the track.
• Some discs may not be played automatically at the wake-
up time.
• When setting the timer set at least one minute between
the start and end time.
Using the sleep timer
The sleep timer switches off the unit after a specified time so
you can fall asleep without worrying about it.
1
Press SLEEP repeatedly to select a switch off
time.
Choose between 10 min, 20 min, 30 min, 60 min, 90 min, 120
min, 150 min, 180 min or OFF. The newly set value displays for
3 seconds, and then the setting is completed.
Note
• The sleep timer can be set by pressing SLEEP while the
remaining time is displayed.
Using Headphones
Connect the headphones plug to the PHONES terminal.
When the headphones are connected, there is no sound
output from the speakers.
STANDBY/ON
TIMER
INPUT
PHONES
AUDIO IN
• Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
• Before plugging in or unplugging the headphone,
reduce the volume.
• Be sure your headphone has a 3.5 mm diameter plug
and impedance between 16
recommended impedance is 32 .
• Audio from the iPod/iPhone/iPad cannot be heard via
the headphones connected to the unit. "HP MUTE" will
be displayed if you connect the headphones when the
iPod/iPhone/iPad function is selected.
VOLUME
and 50 . The
04
15
En