BH FITNESS YF1500 Manual De Instrucciones página 6

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERIES.
To fit the batteries, remove the rear
cover on the monitor (02), Fig.1, and
carefully insert the two "R-6" type
batteries into the battery compartment
(A) making sure that the battery's
polarity is correct
battery's «+» terminal with the «+»
sign inside the battery compartment,
and the «-» terminal with the «-» sign).
Close the cover, as shown in Fig.1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
The monitor will switch itself off
automatically if
motionless for 4 minutes.
Important. Discarded batteries must
be deposited in special containers,
Fig.2.
FITTING THE ELECTRONIC
MONITOR.-
Remove the screws from the back of
the monitor Fig.3, then place the
monitor on top of the main post (03) in
the direction of the arrow, Fig.4,
making sure not to pinch any of the
cables. Refit the screws and tighten,
connect the feedback terminal (77) at
the back of the monitor, as shown in
Fig.3.
uses two 1.5
(matching
the unit remains
English
ELECTRONIC MONITOR.-
volt To give you greater control over the
exercise, this electronic unit provides
simultaneous
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
the exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
A. SCAN FUNCTION.-
In SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES values every 8
2. Press the MODE key and this will
cancel the SCAN function.
B. DISTANCE FUNCTION.-
This function counts up or down in
steps of 0.01 km/ml, up to a maximum
of 99.99 km/ml.
Pressing the RESET key for more
than two seconds will reset all of the
values.
1.Press any key to switch the monitor
on.
2. Press the MODE key to start the
small
flashing.
6
read-outs
mode the
DIST (DISTANCE)
of speed,
computer
seconds.
window