Publicidad
Idiomas disponibles
Idiomas disponibles
English
APPLICATIONS
For charging the HITACHI batteries types BSL14, BSL18 series.
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
1. Connect the battery charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle, the pilot lamp will blink in red. (At
1-second intervals).
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as
shown in Fig. 2.
8
WARNING:
Do not use the electrical cord if damaged. Have
it repaired immediately.
Pilot lamp
Fig. 2
Battery
Guide rail
Publicidad
