Rearward Facing For Group 0; (Birth To 13Kg / Birth To Approx. 18 Months) - Hauck Varioguard Instrucciones De Manejo

GB
vehicle!
REMOVING THE BASE - when attached to the ISOFIX points
Squeeze together the two isofix connection adjustment buttons
(R) located on either side of the support leg at the front of the car
seat base and pull the away from the vehicle seat (20).
Unlock the isofix points (Z) by pulling both latches (Q) toward the
front of the vehicle seat (21).
Then pull the car seat base forward on the vehicle seat to release
from the vehicle (22).

REARWARD FACING FOR GROUP 0+

(Birth to 13kg / birth to approx. 18 months)

Firstly you must install the car seat base into your vehicle using
either the seat belt or ISOFIX points. See sections 'Installing the
base - with a seat belt' or 'Installing the base - with ISOFIX'.
You must also ensure that the harness and headrest is set
correctly for your child, to do this see sections 'Headrest and
Safety Harness Adjustment' and 'Harness Tension and
Adjustment'.
The car seat can be used with an optional seat liner and head
hugger (C1) for small babies, which is available as an accessory.
Please contact your dealer for further information.
INSTALLING THE CAR SEAT INTO THE BASE FULLY
RECLINED
Firstly make sure that the seat is in its fully reclined position. First
click the metal bar on the backrest side of the car seat into the
base of the Varioguard and then the frontal side (9). Each time
you should hear a clear CLICK. Make sure that the safety indica-
tor (V1) fully turned GREEN. (19)
Check the seat is secure by lifting the seat upwards.
To remove the car seat from the base, press the car seat release
button (Y) at the front of the base while lifting the car seat up from
the base (10, 11).
INSTALLING YOUR CHILD IN THE CAR SEAT
Firstly open the buckle by pressing the red button in the centre of
The buckle (26). Then sit your child in the car seat, passing their
32