Publicidad
Start Up
Operation
Percussion drill.
• Set the knob that changes the drive mode to the symbol
• Position the bit at the desired location in the hole, then actuate the
switch.
• Do not force the tool. With less pressure, you get better results. Keep
the tool in the proper position and prevent it from slipping out of the
hole.
• Do not apply more pressure when the hole is clogged with particles or
chips. Instead, actuate the tool with no load, and then withdraw the bit
partially from the hole. If you repeat this action several times, the hole
will be cleaned and normal preforming will resume.
ADVERTENCIA
• When drilling a hole, when the hole becomes clogged with chips and
particles, or when it hits the reinforcing rods of reinforced concrete, a
sudden and tremendous torque is exerted on the tool/drill. Always use
the side handle (auxiliary) and hold the tool firmly by the side handle
and the switch handle during operations. Failure to do so may result in
loss of control of the tool and possibly serious injury.
Chiselling / Carving / Demolition
• Set the knob that changes the drive mode to the symbol
• Hold the tool firmly with both hands.
• Turn the tool on and apply light pressure to the tool to prevent the tool
from bouncing uncontrollably. Excessive pressure with the tool will not
improve efficiency.
Use of the Dust Guard
• Slide the dust cover over the bit before drilling any holes
vertically above your head.
• The dust cover will prevent dust from falling on the tool
and on yourself when drilling.
• The size of the bits to which the dust cover can be fixed
is from 5/16" to 3/8"
Overload Brake
The tool is built with an overload breaker that
stops the axis force (causing a rattling sound)
if the accessory gets stuck. If this happens:
• Turn off the tool immediately.
• Remove the stuck accessory.
• Turn On the tool.
.
.
Additional Information
•SDS accessories need freedom of movement inside the chuck. This
causes eccentricity when the tool is unloaded. However, the
accessory gets centered automatically during the operation with no
affectation the drilling precision.
• When the tool is new it requires 5 hours working to gain its
maximum efficiency.
• When using the tool in the drill or hammer drill mode first, set the
bit tip in the point where the orifice will be bored and then press the
switch.
9
ENGLISH
Publicidad
