Publicidad
Preparation
Installing or removing the bit/accessory
• Clean and lubricate lightly the bit and / or accessory
before installing.
• Push the chuck jaw back while turning and pushing the
bit/accessory in until it engages.
• Release the chuck jaw to set it in the original position. This procedure
will secure the bit and / or accessory. If the chuck jaw is not back to the
original position repeat the former step.
• After installing, always make sure the bit is firmly in place by trying to
pull it out.
• To remove the bit, pull down on the bit sleeve and push the bit out.
WARNING
Do not try to install or remove bits and / or accessories
unless the tool is disconnected.
Start Up
Turning ON and Operation Control
• Operation:
Connect the plug into the power supply.
Press the trigger switch (A) to start the hammer Drill.
To stop the use, just release the switch.
• Speed change:
• The tool can be operated in different speeds. Select,
adjusting the speed selector (+ and -) (B).
Speed
High
Medium
Low
Operation mode
Rotary Hammer / Chiseling
Drill
Rotary Hammer / Drill
1
2
Material or Use
Concrete and Stone
Metal
Start holes
Bit with
SDS-PLUS Shank
Chuck
Jaw
ENGLISH
7
Publicidad
