Publicidad
Changing the Operation Mode
• Turn both function selectors (C) into one of the 2
positions to determine one of the four configurations,
depending what is the job to carry out.
Never change the position in the
WARNING
function selectors when the hammer drill motor is
running.
Drill
Wood, metal or plastic drilling
Metal, wood or plastic can be drilled with
the tool using drill / accessory bit three
jaws chuck with an SDS adapter (NOT INCLUDED).
• To install the three jaws chuck, go as with any other SDS accessory
(page 7, Installing or removing the bit / accessory).
• Set the bit into the three jaws chuck until is stops and secure with
the chuck key tightening each one of the orifices alternatively.
WARNING
Never use the three jaws chuck with the selector
in the operation mode in the IMPACT positions (
8
ENGLISH
Hammer Drill
,
,
Start Up
).
Chiseling
(The chisel does not have a
100% fixed )position.
Publicidad
