OPERATION - General
The appliance is intended only for domestic use,
not for professional use.
Overview
1. Permanent filter
2. Thermal carafe (2x)
3. Filter holder with
pause-and-serve function
4. Water reservoir lid
5. Water reservoir
6. Water-level indicator
7. Start button with control light
8. Power chord and plug
9. Release button
10. Lid
OPERATION - Before first use
Clean the appliance a couple of times by filling it with water only. Please observe the
following instructions. Dispose of the water after use.
OPERATION - Making coffee
1. Place the appliance on a flat and steady surface. Remove the thermal carafe (2) from the platform.
2. Open the lid (4) of the water reservoir (5). Pour sufficient water into the reservoir (not less than 4 cups,
as shown on the water-level indicator (6)).
3. Open the lid (10). Use the permanent filter (1) or put a paper filter (1 x 4) in the filter holder. Fill the paper
filter with the required amount of ground coffee (the customary quantity is 1 level scoop for each cup).
4. Place a thermal carafe on the platform.
5. Connect the plug (8) to the wall socket. Switch on the appliance by pushing the start button (7). The
control light will now illuminate and the coffee will be prepared.
6. The coffee maker switches off within 8 minutes when the coffee is ready. The pilot light of the start button
(7) is then off. Replace the carafe quickly, to prevent the filter from overflowing.
7. The coffee machine automatically stops when the brewing is done. If you wish to halt the brewing
prematurely, you can push the start button again. The control light will extinguish.
8. Remove the plug from the wall socket.
WARNING:
•
Allow the appliance to cool down before using it to brew additional coffee!
3
1
24
9
2
EN
10
4
5
max
8
6
6
4
7
8