Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
CLEANING AND REPLACING THE FILTER
For optimal suction power, after each use, clean and reinsert the filter inside the robot's dust bin.
See sharkaccessories.com for replacement filters.
Remove and empty the dust bin. Clean any hair or
debris off the Anti-Tangle Comb on the back of
the dust bin.
Lightly tap the filter to remove debris every time
you empty the dust bin. For a deeper clean, rinse
the filter with water once a month. Allow the filter
to air-dry for up to 24 hours before reinstalling.
s h a r kc l e a n . c o m
Pull filter out of the dust bin by the tabs.
Reinsert the filter into the dust bin, then slide the
dust bin back into the robot until it clicks into
place.
MAINTENANCE
SELF-CLEANING BRUSHROLL
The Self-Cleaning Brushroll actively removes hair wrap while your robot cleans. If some debris remains
wrapped around the brushroll, continue to run the robot to give the brushroll time to clean itself. If some hair
wrap or debris remains after continued cleaning, carefully remove it from the brushroll.
To access the brushroll, push up on the tabs on the
brushroll door, then lift off the door.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
Lift out the brushroll and remove any debris.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down until
both sides click into place.
s h a r kc l e a n . c o m
Publicidad
