Stanley ST-12F-E Manual De Instrucciones página 22

1. Take out the all spare parts from box, fix the
metal tube on the fan body. See Figure 5.
2. Install wheels(Fx2) to the on the two sides of
short metal tube(Cx1), then fix it to the bend
metal fan(Bx2), see Figure 6.
3. Install the long metal tube(Dx1) to the other side
of bend metal tube, See Figure 7.
4. Insert the metal tubes into the metal base by
pressing spring buttons. See figure 10. See
Figure 8.
5. Press metal tube in to Metal base until spring
button protrudes out open hole in metal tubes.
See Figure 11.
6. Loosen the nut, fix the handle to the one side of
fan body, tightening the nut. See Figure 9.
© 2023, Obelis S.A Registered Address:
Bd. Général Wahis, 53 1030 Brussels, Belgium
NEVER LEAVE A FAN UNATTENDED WHILE
OPERATING OR WHILE CONNECTED TO A
POWER SOURCE
ST-30BCT-E
Ax1 Bx2
Fx2 Hx2
Figure 5
Ax1
Ix2
Hx2
Ex4
Figure 7
Figure 9
Figure 10
6
Cx1 Dx1
Ix2 Jx2
Figure 6
Figure 8
Jx2
Dx1
Figure 11
Metal
Base
Spring
Button
Spring
Button
Metal
Tube
Ex4
x1
Cx1
Fx2
Bx2