Stanley ST-12F-E Manual De Instrucciones página 24

Wall Mount Installation
Tools Needed:
• Phillips screwdriver
• Adjustable wrench
1. Secure the wall mount to the desired location with
appropriate hardware (not provided).
2. Attach the bend pipe to the wall mount with the
provided bolts. Tighten the bolts.
3. Loosen the Phillips head set screw on the lower
supporter. Attach the motor to the bend pipe by
using the M12x32 screw, nut, and washer to
connect the lower supporter to the upper supporter.
Tighten the M12x32 screw and the Phillips head
set screw. Ensure the screws are tight.
Operating Instructions
1. Confirm that the speed control knob is set to "O" off. Plug the cord into a 220-240VAC outlet.
2. Adjust to the desired speed setting.
Front Guard
NOTE: The bolts and screws are mix of metric and standard.
© 2023, Obelis S.A Registered Address:
Bd. Général Wahis, 53 1030 Brussels, Belgium
NEVER LEAVE A FAN UNATTENDED WHILE
OPERATING OR WHILE CONNECTED TO A
ST-24W-E, ST-30W-E
• 10mm socket
Exploded View
Set
Screw
Blades
M5x12mm
M3x10mm
POWER SOURCE
The installer MUST be certain that the
WARNING
support bracket is mounted to a mini-
mum of a 2x4" stud, and that it is able to support 50
pounds continuously.
4. Remove the four (4) M5x12 Phillips head flange
screws from the motor.
5. Attach the rear guard to the motor with the four (4)
M5x12 Phillips head flange screws.
6. Attach the blade to the motor shaft by using 10 mm
socket. Make sure the set screw is facing toward
the motor (hub down) when attaching.
7. Attach the front guard to the rear guard, using the
snap joint to tighten.
Rear Guard
M3
M12x32mm
8
Motor
M12
M6x6mm
M8x12mm
Bend Pipe
Wall Mount
M8x40mm