Publicidad
Idiomas disponibles
Idiomas disponibles
TABLE FAN ASSEMBLY
A. To assemble the grilles, propeller on the motor body, follow points n. C-D-E-F- of the previous paragraph.
B. Remove the fixing screw (7) with the respective nut from the body.
C. Insert the lower part of the body into the base (16) so that the clips and the groove coincide: secure it with
the 3 screws provided (17).
WALL FAN ASSEMBLY
A. The appliance must only be used if secured to a wall: the wall must be flat, smooth, very stable (as the
appliance could tip over) and resistant.
B. Check that the free space on the sides is at least 30cm.
C. If the appliance is fitted to a wall, the same must be made of masonry and/ or of resistant material (not
of wood or synthetic material) first check to see if pipes (water, gas, etc.) or electrical cables are
embedded in the area you will use for mounting the brackets; follow the indications below for
installation:
1) "L" screw
2)
Base
3)
Fan fixing ring nut
4)
Drive shaft
5)
Rod fixing ring nut
6)
Adjustable hose
7)
Floor fixing screw
8)
Selectors
9)
Ring screw
10) Front grill / protective screen
11) Rear grill
12) Propeller
13) Column
14) Rear grill fixing ring nut
15) Button oscillation right/left
16. Base table
17. Screws
14/44
Publicidad
