Publicidad
Idiomas disponibles
Idiomas disponibles
c1.The wall fan must be installed at least 2 m above the floor
c2. Place the plate to the wall, make 4 holes in the wall, as far apart (before drilling holes is good to
measure the distance between the slots above), insert the screw anchors into the holes, place the plate
and tighten the screws
D. To assemble the grilles, propeller on the motor body, follow points n. C-D-E-F- of the previous paragraph.
Notes: the three base fixing screws (17) must be removed from the lower part of the body.
E. Hang the appliance on the bracket so that the two grooves coincide: secure it with the fastening screw (7).
F. At the end of the work, check that the motor body and bracket are firmly coupled and integral with the
motor.
USE
Plug the fan in the power supply.
Ventilation: select the desired speed with the selectors (8):
1 – Minimum speed
Horizontal oscillation (right-left): this is selected with the button (2) located on the motor body. To stop the
motion and keep the ventilator still, press the button.
Vertical inclination (high-low): it is regulated by gripping the motor body and orienting it in the direction
desired; you will hear "clicks" that indicate the fan's various positions.
To turn the fan off, press the "0" key and then remove the plug from the socket.
When not in use for long periods, the plug must always be removed from the socket.
CLEANING AND MAINTENANCE
Attention: before normal cleaning, remove the plug from the socket.
• Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive products.
• Do not immerse any part of the fan in water or other liquid: if this should happen, do not put your
hand in the liquid, but first remove the plug from the socket. Carefully dry the appliance and make
sure that all the electrical parts are dry: in the case of doubt, ask for professionally qualified help.
• It is essential that the motor's air holes be kept from dust and lint.
• Periodically check the electric cord for damage; its replacement requires a special tool: contact an
authorized service center, also for any repairs.
2 – Medium speed
18. Plate
19. Screws
20. Screw anchors
3 – Maximum speed
15/44
0- Off
Publicidad
