Roger Technology H85/TDR Instrucciones Y Advertencias Para El Instalador página 17

Procedure for fixed code radio transmission:
Procedure for rolling code radio transmission:
If the procedure is successful, the green LV LED on the keypad lights up for 2 s. The buzzer sounds until the LED goes
out.
If the procedure is NOT successful, the red LR LED on the keypad blinks rapidly 5 times and the buzzer sounds
intermittently.
12
Complete memory erasure (fig. 13)
All user codes can be deleted from the memory, of the H85/TDR wireless code keypad, digiting in sequence, using the
last password entered (example last password entered 12345):
If the password is correct, the green LV and red LR LEDs on the keypad blink slowly for 2 s, while the buzzer sounds
simultaneously.
13
Advanced function: Code masking
WARNING! This feature is available for 6-digit user codes, to improve security when entering the code.
The mask function allows the real code to be "hidden" among digits entered at random.
The code will be read from the 6 digits entered immediately before the (*) star key.
E.g. user code 245672, channel enabled CH_B.
294862...308236 245672 * 057986...791964 * B
N.B: by simply entering 245672 * * B, code masking can be bypassed.
14
Indicators
ERROR ALERT H85/TDR KEYPAD
LR LED blinks rapidly 5 times
Intermittent buzzer
Alternately blinking LV and LR LEDs
LEDs LR and LV light simultaneously while using
the keys.
If the error alerts persist, contact Technical Service.
15
Cancelling a channel key from the receiver
Cancel a channel key of the H85/TDR keypad from the radio receiver as follows:
• Press and hold button P1 or P2 for the channel where the channel key you want to cancel is stored, for 4 seconds.
• The relative LED L1 or L2 lights and then starts to flash rapidly.
• Release button P1 or P2, the LED L1 or L2 continues to flash rapidly.
• During this period, enter the user coder stored previously (e.g. 34741) then press the asterisk key (*) and the key/
channel of the H85/TDR keypad you want to cancel (e.g. 1/A CH_A).
• The LED L1 or L2 lights for 1 s.
• Repeat the procedure to cancel any other keys/channels from the radio receiver.
* * 12345 * (the red LR LED lights up) 0000 * 0000 *
* * 12345 # (the red LR LED lights up) 0000 # 0000 #
# # * 12345 # # *
POSSIBLE CAUSE
Incorrect password
User coder not in memory
User code or password entered with fewer than 3 digits or more than 6
In code delete mode or change password mode: the codes entered do not match
the confirmation codes.
User code already stored.
Failure to enter * after the user code.
Digit entered incorrectly: # instead of *.
User code entered incorrectly 5 times in a row. Keypad locks for 20 s.
Batteries flat. The keypad is disabled until the batteries are replaced.
Batteries low. Replace the batteries as soon as possible.
17 17