Roger Technology H85/TDR Instrucciones Y Advertencias Para El Instalador página 18

16
Replacing the batteries (fig. 6)
WARNING! Always use batteries of the same brand. Always replace both batteries at the same time. Do not use an
old battery with a new battery.
To replace the batteries:
• Remove the side panels, then undo and remove the screws. Pull off the numerical keypad (fig. 6).
• Disconnect the battery connector (fig. 6 detail A) from the electronic circuit board of the wireless keypad.
• Undo the screw fastening the battery holder (detail B). Open the battery holder and replace the batteries, ensuring
that they are fitted with the correct polarity as indicated (detail C).
• Do not use metal tools (such as tweezers), as this may cause short-circuiting.
• Close the battery holder and fasten to the keypad base with the screw (detail B).
• Connect the connector to the electronic circuit board (det. A).
• Refit the numerical keypad, fasten with the screws and refit the lateral panels correctly.
17
Initial testing
• Power on.
• Press the channel keys 1/A, 4/B, 7/C and */D programmed in the memory of the receiver to check that the receiver
outputs function correctly.
• The green LED LV should light briefly and the buzzer should sound when a user code is entered.
• If fixed mode is selected, check that the red LED LR flashes during transmission. If rolling mode is selected, check
that the green LED LV flashes during transmission.
18
Maintenance
Perform scheduled maintenance every 6 months.
Check cleanliness and correct functioning.
If any dirt, moisture, insects or other foreign matter is present in the unit, disconnect from mains power and clean the
board and the housing.
Repeat the initial installation test procedure after cleaning (chapter 16).
If any corrosion is found on the printed circuit board, evaluate if it is necessary to replace the board itself.
19
Disposal
This product may only be uninstalled by qualified technical personnel, following suitable procedures for
removing the product correctly and safely. This product consists of numerous different materials. Some of
these materials may be recycled, while others must be disposed of correctly at the specific recycling or
waste management facilities indicated by local legislation applicable for this category of product.
Do not dispose of this product as domestic refuse. Observe local legislation for differentiated refuse
collection, or hand the product over to the vendor when purchasing an equivalent new product.
Local legislation may stipulate severe fines for the incorrect disposal of this product. Warning! some parts of this
product may contain substances that are harmful to the environment or dangerous and that may damage the
environment or pose a risk to health if disposed of incorrectly.
20
Additional information and contact details
ROGER TECHNOLOGY is the exclusive owner of all rights regarding this publication.
ROGER TECHNOLOGY reserves the right to implement any modifications without prior notification. Copying or scanning
of or any alterations to this document are prohibited without the express prior permission of ROGER TECHNOLOGY.
This document is in printed form; any updates are available in the restricted area of our website www.rogertechnology.
com/B2B
ROGER TECHNOLOGY CUSTOMER SERVICE:
business hours:
Telephone no:
E-mail:
Skype:
18 18
Monday to Friday
8-12 am and 1.30-5.30 pm
+39 041 5937023
service@rogertechnology.it
service_rogertechnology