Roger Technology H85/TDR Instrucciones Y Advertencias Para El Instalador página 16

9
Activating a user code / transmission
Enter the previously stored user code (e.g. 34741) followed by star (*).
If the code has been stored in the memory, the keypad's green LV LED lights up.
Press and hold the enabled key/channel (e.g. 4/B - CH_B).
Example:
If ONLY ONE of the channels CH is enabled (1/A...4/B ...7/C...*/D), radio transmission is activated immediately after the
user code is entered followed by pressing the * (asterisk) key:
EXAMPLE with user code 89512 and channel CH_A enabled.
N.B.: transmission continues as long as the asterisk key (*) is held; the H85/TDR keypad switches off as soon as the
key is released.
WARNING!
• A maximum of 5 s may elapse between pressing one key and the next, otherwise an error alert is activated (the red
LR LED blinks rapidly 3 times) and the code must be entered again.
• Pressing a key/channel that has not been enabled (1/A, 4/B etc.) does not activate radio transmission.
• In case of error while entering the code, press # to exit activation mode.
10
Deleting a user code (fig. 12)
Identify the user code (e.g. 34741) to be deleted, and enter in sequence:
If the code is present in the memory, the red LR LED blinks and then remains steady-on.
Confirm within 5 s, by entering
If the two codes have been entered correctly (the same), the procedure is successful and the green LV LED lights up for
2 s. The buzzer sounds until the LED goes out.
Using again our example with user coder to delete 34741:
11
Changing password (fig. 8)
For the security of the installation, it is recommended to change the password from the factory default value 0000.
The "change password" operation also selects the type of encoding of the radio transmission: fixed code or "rolling
code".
Therefore, if you only wish to change the type of encoding without changing the password, you must carry out the
sequence described, taking care to keep the password.
The factory default password is 0000.
Change password from 0000 to 12345, tx radio fixed code, enter in sequence:
Change password from 0000 to 12345, tx radio rolling code, enter in sequence:
If the procedure is successful, the green LV LED lights up and the buzzer sounds for 2 s.
If the procedure is NOT successful, the red LR LED blinks rapidly 5 times and the buzzer sounds intermittently.
11.1
Reset password to factory setting (fig. 9)
If the password is lost/forgotten, it can be reset to the factory default value (0000) by knowing any of the user codes
stored in the H85/TDR.
To reset the password, if for example the user code 12345, is known, enter in sequence:
16 16
34741 * B
89512 * (CH_A transmit)
# # 34741 *
34741 *
# # 34741 * 34741 *
* * 0000 * (the red LR LED lights up) 12345 * 12345 *
* * 0000 # (the red LR LED lights up) 12345 # 12345 #