Publicidad
Idiomas disponibles
Idiomas disponibles
Then take the rear stabiliser bar (20A)
and carry out the same assembly
operation as with the front stabiliser
bar, tighten up all of the nuts (23)
securely.
4.- ATTACHING THE SADDLE.-
Remove screws (39) and washers
(38) from the bottom of the saddle
(33). Fit the saddle (33) in the
direction of the arrow, Fig.4, onto the
saddle post plate (34), making sure
that the holes in the saddle post are
facing the front part of the saddle, and
tighten the nuts securely.
Next, insert the saddle post into the hole
(A) Fig.5, on the main body (1), fit the
saddle post adjustment knob (25),
adjust the position of the saddle post
and tighten the knob (25) by turning it
clockwise.
5. FITTING THE HANDLEBAR.-
Bring the handlebar (40) up to the
handlebar stem (1), slot as shown in
Fig.6, refit the screws (41), the
washers (21) and the spring washers
(43), Fig.6, and tighten securely.
6.- FITTING THE ELECTRONIC
MONITOR.-
Position the bracket (45) on the
handlebar (40), as shown in Fig.7, and
tighten the screw (46).
Plug
terminal
terminal at the back of the monitor (42),
as shown in Fig.7, slide the front of the
monitor down onto the bracket (45),
making sure not to snag any of the
wires Fig.7.
7.- ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the
letter, fitting these incorrectly could
(B)
feedback
damage the screw thread on the
pedal or the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right pedal (9R) is marked with
the letter (R).This screws onto the
right-hand crank, also marked with an
(R), in a clockwise direction.
Tighten securely Fig.8.
The left pedal (9L) is marked with the
letter (L).This screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction.
Tighten securely Fig.8.
8.- EXERTION SETTINGS.-
To provide an even level of exertion
during exercise, this appliance is
equipped with a tensioning control
(37), located on the main post, offering
various exertion settings, Fig.9.
To increase pedal resistance turn the
tensioning control (37) clockwise (+)
until the exertion level best suits your
exercise requirements. To reduce
pedal resistance turn the tensioning
control (37) anticlockwise (-).
9.- STORAGE
If you want to store your unit in
minimum space, follow the next steps.
Fold up the unit (1) following the
arrows. Place the safety pin (47) in its
into
housing, as shown in Fig. 10.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
11
Publicidad
