Roadstar HRA-1520 Manual De Instrucciones página 3

WARNINGS
The exclamation point within the triangle is a warning sign alert-
ing the user of important instructions accompanying the
product.
The lightening flash with arrowhead symbol within the triangle
is a warning sign alerting the user of "dangerous voltage" inside
the unit.
To reduce the risk of electric shock, do not remove the cover. No
CAUTION
user serviceable parts inside the unit. Refer all servicing to
RISK OF ELECTRIC
SHOCK
DO NOT OPEN qualified personnel.
230v~
This unit operates on 230V ~ 50Hz. If the unit is not used for a
long period of time, remove the plug from the AC mains.
Make sure all batteries are inserted according to the proper
- +
polarity. Do not mix old batteries with new ones.
If the unit is not used for a long period of time (more than 1
- +
month), remove all batteries from their compartment to avoid
possible leaking.
This unit must not be exposed to moisture or rain.
The power switch in this unit is mounted on the secondary
circuit and does not disconnect the whole unit from the mains in
OFF position.
Ensure all connections are properly made before operating the
unit.
This unit should be positioned so that it is properly ventilated.
Avoid placing it, for example, close to curtains, on the carpet or in
a built-in installation such as a bookcase.
Do not expose this unit to direct sunlight or heat radiating sources.
1
English
1 2
HRA-1520 AM / FM WOODEN RADIO
CONNECTING TO POWER
Before switching on make sure that the voltage of your electricity supply is the same as that
indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect this unit
to the mains.
AC 230 V OPERATION
To operate the connect the plug end (7) into a 230V AC 50 Hz electric source and to
switch ON/OFF the unit when using the main power set the switch to ON (1).
BATTERY OPERATION
•
•
•
•
RADIO OPERATION
1. Turn the unit ON with main Switch (1) when powered with AC-230V or with battery.
2. Extend the wire antenna (2) for FM Band. To optimize MW reception turn horizontally the
radio until reaching the best reception position.
3. Select the desired radio Band: MW (3) or FM (4).
4. Tune to the desired station with the Tuning knob (5).
5. Adjust the volume by turning the VOLUME control (6).
SPECIFICATIONS
External power supply: 230V AC
Frequency range:
Dimensions:
Features and design could be subject to variations without prior notice.
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
This marking shown on the product or its literature, indicates that it should not be disposed with
other household wastes at the end of its working life. To prevent possible harm to the environment
or human health from uncontrolled waste disposal, please separate this from other types of wastes
and recycle it responsibly to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they purchased this product, or their local
government office, for details of where and how they can take this item for environmentally safe
recycling. Business users should contact their supplier and check the terms and conditions of the
purchase contract. This product should not be mixed with other commercial wastes for disposal.
English
Open the Battery Compartment (8) at the rear of the radio and insert six UM-2 batteries
following the polarity diagram shown inside the battery compartment.
Batteries should be removed form the compartment if the unit is not to be used for
some time.
Flat batteries should be removed from the unit to avoid leakage.
To switch ON / OFF the unit when powered with the battery, please use the Switch (1).
FM (87.5 - 108MHz)
MW (530 - 1600kHz)
280 x 190 x 135 mm