Jata electro PL501N Instrucciones De Uso página 12

• Open the filling lid (5) and pour water into the tank using the cup provided.
• Do not go over the MAX indication of the tank (9) to avoid overflowing.
• Replace the lid.
• Connect the iron to the network. The indicator (10) and the auto shut off indicator (1) will light up. Note that the
auto shut off indicator is lit as long as the iron is connected to the network.
• Place the steam iron in vertical position.
Attention:
It is important to place the iron in vertical position because if it is leave it in horizontal position the auto off
system could be connected before the iron has reached the selected temperature.
• Once the pilot light (10) goes off, turn the steam knob (4) to the maximum steam indication
desired amount of steam.
SUPER STEAM
• The temperature selector (8) must always be set to its maximum position (MAX).
• Press and release the button (3). Repeat this operation at intervals between each time you press the button.
• If you wish to obtain a greater super-steam set the steam control knob (4) to the off (0) position.
VERTICAL IRONING
• It allows you to remove creases from the garments without them having to be lying on the ironing board: jackets
and coats may be pressed on their hangers; as may be hanging curtains and such.
• Close the adjustable steam knob (4) and place the temperature selector to the (MAX) position.
• Bring the iron close to the garment in a vertical position and press the steam button (3).
SPRAY IRONING
• To obtain a spray, the temperature selector (8) position is unimportant.
• Press the spray button (2). In case no water should come out, press the button again.
DRY IRONING
• If there is water in the tank, set the adjustable steam knob (4) to the off position (0).
• Plug the iron into the mains and place the selector (8) in the desired temperature for each fabric:
- FIBRAS SINTÉTICAS : SINTHETIC FIBRES: Low temperature (•)
- SEDA – LANA : SILK – WOOL: Medium temperature (••)
- ALGODÓN – LINO : COTTON – LINEN: High temperature (•••MAX)
AUTO-CLEANING SYSTEM
• Set the adjustable steam knob (4) to the off position (0).
• Pour water into the tank.
• Set the temperature selector (8) to MAX position and plug the iron to the mains.
• As soon as the indicator light (10) is off, place the iron in a horizontal position on a plate or suitable container in
the sink and remain pressed the auto-cleaning CALC CLEAN (7) button. The steam and drops of water will begin
to flow from the orifices in the base of the iron draining the dirt and particles.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning the appliance ensure the appliance is unplugged from the mains and let the
appliance to cool.
• The sole plate can be cleaned with a cloth soaked with vinegar. This whole operation is more easily carried out
when the sole plate is warm.
• The exterior parts of the iron may be cleaned with a slightly dampened cloth.
• Do not use abrasive or chemical products, metallic scourers, which may deteriorate the surfaces of the appliance.
• To store the iron, ensure there is no water left in the tank, set the steam control to the off position and always
store in a vertical position.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
12
until getting the