Bimar NSC-60-7 Folleto De Instrucciones página 12

• In the case of a breakdown or fault, switch the appliance off and have it
checked by a professionally qualified technician; repairs made by
unqualified people can be dangerous and render void the warranty.
• All repairs should be made by a competent qualified electrician. Any
faulty appliances should be returned to this service.
• This radiator is filled with a precise quantity of special oil. Repairs that
require to open the oil container, are only to be made by the
Manufacturer or his service agent, who should be contacted if there is
an oil leak.
• When scrapping the heater, follow the regulations concerning the
disposal of oil.
INSTALLATION
• After removing the packing materials, check that the appliance is in perfect condition; if you
are unsure, do not use it and ask for qualified professional help. The packing materials
(plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children because
they are potential sources of danger; they must be disposed of in accordance with current
law.
All packaging elements must be disposed of according to their raw material (see the symbol
stamped on each one) and according to the provisions of their municipality. The bag
containing the set bracket, which is unmarked due to its small size, therefore you have to
follow the procedures for the disposal of their municipality.
• Before connecting the appliance, check that the voltage shown on the data plate matches
that of your local power supply and that the electric plug is grounded. In the event of
incompatibility between the electric outlet and the appliance plug, replace the outlet with
another more suitable type by professionally qualified personnel, who will make sure that
the outlet wiring section is appropriate for the absorbed power of the appliance. In general,
the use of adapters or extension cords is not recommended; if their use cannot be avoided,
they must conform to existing safety standards and their current capacity (amperes) must
not be less than the maximum appliance capacity.
• The appliance must be positioned at a safe distance from heating sources, inflammable
materials (curtains, cloth, etc.), inflammable gas or explosive materials and from materials
that may be deformed by high temperatures. Make sure that a space of at least 1 metre is
left free in front of the appliance, and 50 cm of free space at each side.
• Stand the appliance on a horizontal, flat surface or table; Never place the appliance on a
sloping surface as this can cause it to fall over. Never lay the electric cord under rugs or
carpets.
• Make sure that the cable is positioned correctly, that it is not in contact with hot elements
or sharp edges, that it is not wound around the appliance, that it is not twisted, or in a
position which can cause the appliance to fall over. Check that the cable cannot cause
tripping in order to prevent accidental falls or injury.
12