Bimar NSC-60-7 Folleto De Instrucciones página 13

ASSEMBLY
The supplied base is composed of two plastic brackets: the horizontal one is inserted beneath
the plastic panel, and the vertical one is then inserted on the end element. The brackets must
be fastened to the lower part (see up-down arrow on the plate fixed to the appliance) and
must adhere perfectly to the surface to which they are attached.
Follow these steps for assembly (see figura):
Warning: the radiator may be used only and exclusively when the base is assembled correctly.
Thanks to its base, the radiator does not heat the surface on which it rests, the air is conveyed
naturally, and the appliance can easily be moved thanks to the retracting handle on the
"dashboard".
Attention: for the first use, leave it operaning at maximum power for at least two hours. During
this opearation, ventilate the room well to eliminate the "new" smell emanating from the
appliance.
APPLIANCE USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent
qualified electrician or a person with similar qualifications, in order to avoid any risk.
The radiator can be adjusted as follows:
- Room thermostat. Set (using relative knob 2 ) the room temperature and start the radiator
in continuous mode until the set temperature is reached: if this drops, the radiator restarts
for the time necessary to re-establish the set value. If the knob is turned completely anti-
clockwise, the radiator remains off, if it is turned completely clockwise the maximum
temperature is set; for intermediate values the temperature increases as the knob is turned
towards the Maximum position and vice versa.
- Signal lamp (pos.3): indicates when the radiator is on, or rather, that the resistance is in
function.
Follow these steps to use the radiator correctly:
1) Check that the thermostat knob is in position "0" (off).
2) Insert the plug into the power socket.
3) Turn the thermostat dial (2) to the position of the required temperature.
4) To switch off the appliance, turn the thermostat knob to pos. "0" and remove the plug
from the power socket.
Attention: Never move the appliance when it is switched on. Once it has been switched off,
the appliance requires several minutes to cool down: wait until it has cooled down
completely before moving it; the appliance can be moved easily by using the handles at the
sides.
Never leave the appliance connected to the socket if it is not in use, especially for long
periods.
1) Insert the horizontal bracket in its relative guide under the
plastic panel: push in until it clicks into place.
2) Insert the vertical bracket under the last external element:
push hard until completely inserted.
3) Check that the brackets are perfectly level and that the
radiator is perfectly vertical. Before switching it on, leave the
radiator in a vertical position for a few minutes so the oil is equally
distributed inside.
13