Descargar Imprimir esta página

Ryobi P2502 Manual Del Operador página 26

Ocultar thumbs Ver también para P2502:

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: New chains tend to stretch; check the
chain tension frequently and adjust as needed.
NOTICE:
A chain tensioned while warm may be too tight
upon cooling. Check the "cold tension" before
next use.
CHAIN MAINTENANCE
See Figures 31 - 32.
WARNING:
Remove the battery pack and make sure the
chain has stopped before you do any work on
the saw to avoid accidental starting and pos-
sible serious personal injury.
Use only low-kickback chain on this saw. This
fast-cutting chain will provide kickback reduction
when properly maintained.
For smooth and fast cutting, chain needs to be
maintained properly. The chain requires sharpen-
ing when the wood chips are small and powdery,
the chain must be forced through the wood dur-
ing cutting, or the chain cuts to one side. During
maintenance of your chain, consider the following:
 Improper filing angle of the side plate can
increase the risk of a severe kickback.
 Raker (depth gauge) clearance.
 Too low increases the potential for kickback.
 Not low enough decreases cutting ability.
 If cutter teeth have hit hard objects such as nails
and stones, or have been abraded by mud or
sand on the wood, have service dealer sharpen
chain.
NOTE: Inspect the drive sprocket for wear or dam-
age when replacing the chain. If signs of wear or
damage are present in the areas indicated, have
the drive sprocket replaced by a RYOBI Service
dealer.
HOW TO SHARPEN THE CUTTERS
See Figures 33 - 34.
Be careful to file all cutters to the specified angles
and to the same length, as fast cutting can be
obtained only when all cutters are uniform.
MAINTENANCE
RIVET HOLE
26 - English
CUTTING CORNER
TOP PLATE
HEEL
GULLET
CHECK FOR WEAR
OR DAMAGE
LEFT HAND
CUTTERS
RIGHT HAND
CUTTERS
SIDE PLATE
DEPTH GAUGE
TOE
Fig. 31
Fig. 32
Fig. 33
Fig. 34

Publicidad

loading