Reversing the door
The door can be changed from left and right side. No special requirement, all the door is opened from left
side. If require to open from right side please refer to the following direction:
1. Incline the wine cooler with 45 degrees, take out right lower hinge's screws with screwdriver (Fig.1).
2. Level the wine cooler, hold the door and take out right upper hinge's screws with screwdriver, then
take out the door, put the door safety and rotate it at 180 degree (Fig.2, Fig.3 & Fig.4).
3. Remove limited block B as per the arrows in picture, then release all the screws on limited block A,
and take away limited block A. Install the limited block A at the right side with screws, then install
limited block B, then fit the door with screws (Fig.5, Fig.6 & Fig.7).
Note: this is a two person operation
39