Siemens VBH14401 Instrucciones De Uso página 25

en
Fold out the picture pages.
Before using for the first time
Fitting the charger
The charger can be used either fitted to the wall or
mounted on its floor support.
1
Figure
If fitting the charger to the wall, select a location
close to a socket and mount the charger (without its
floor support) on the wall using the screws provided.
2
Figure
When using the charger mounted on its floor support
fit the charger onto the base.
3
Figure
Plug the charging cable into the connection at the
side of the contact arm.
4
Figure
Raise the handle and lock into place
To fold the handle back down, press the unlocking
knob and release the handle catch.
5
Figure
Plug the handstick vacuum cleaner into the floor tool
and lock into place.
To release the floor tool, press the unlocking knob
and pull the handstick vacuum cleaner out of the
tool.
6
Figure
Insert the handheld vacuum cleaner into the
handstick vacuum cleaner as shown and lock into
place.
!
Make sure that the contacts of the handheld
vacuum cleaner and handstick vacuum cleaner are
not dirty. Clean the contacts if necessary.
7
Figure
Insert the handstick vacuum cleaner into the charger
as shown.
!
Make sure that the contacts of the handstick
vacuum cleaner and charger are not dirty. Clean the
contacts if necessary.
When the handstick vacuum cleaner is inserted into
the charger, the appliance is automatically switched
off, should it have still been left on by mistake.
!
Before using the appliance for the first time, the
vacuum cleaner batteries must be charged for at
least 16 hours.
Plug the charger plug into the socket.
The charging indicator lights up.
The indicator remains lit for as long as the vacuum
cleaner is connected to the mains via the charger.
It does not go out even when the vacuum cleaner
batteries are fully charged.
It is normal for the charger and vacuum cleaner to
become hot and not a cause for concern.
You can charge the vacuum cleaner at any time when
it is not in use. In this way, it is always ready for use.
Vacuuming
Using the handstick vacuum cleaner
8
Figure
Remove the appliance from the charger and operate the
on/off switch in the direction of the arrow.
The on/off switch can be moved to the following
two positions:
Position 1 = medium power setting
=> The appliance has a longer run time.
Position 2 = high power setting
=> The appliance has more power for a shorter
run time.
The function indicator on the floor tool lights up,
indicating that the brush roller is turning.
9
Figure
During short pauses in vacuuming, the appliance can
be left standing upright anywhere in the room. To do
this, tilt the vacuum cleaner forwards slightly in the
direction of the nozzle.
!
Caution: When the appliance is left standing,
it must be switched off, because if the brush is
turning while the appliance is standing still, it
could cause damage to the floor covering.
10
Figure
After vacuuming, switch the appliance off and return
it to the charger.
Caution!
Floor tools are subject to a certain amount of wear,
depending on the type of hard floors you have
(e.g. rough, rustic tiles). Therefore, you must check
the underside of the floor tool at regular intervals.
Worn undersides of floor tools may have sharp edges
that can damage sensitive hard floors, such as parquet
or linoleum. The manufacturer does not accept any
responsibility for damage caused by worn floor tools.
23