Publicidad
Idiomas disponibles
Idiomas disponibles
5
Audio from the FM/AM, PHONO, TAPE (cassette tapes) or AUX
sources can be recorded on the CD recorder.
1
Press the PHONO/TAPE/AUX button or the FM/AM button
repeatedly to select the source to be recorded.
To record a record or cassette tape, select PHONO/TAPE and set
the INPUT switch by the turntable to the desired source.
To record an external source connected to the AUX IN jacks,
select AUX.
2
Load a recordable CD-R or CD-RW disc into the unit.
Press the OPEN/CLOSE button (L), place a disc on the disc tray
with the printed label side up, and then press the OPEN/CLOSE
button (L) to close the disc tray.
Make sure "NO TOC" and "CD-R" (or "CD-RW") indicators lights on
the display, or the RECORD button in step
Recording 1
3
< When you record a radio broadcast, press the MANUAL/AUTO
– – (MANUAL)
–20db, –30db or –40db (AUTO REC)
4
will not work.
To record a radio broadcast
Select FM or AM using the FM/AM button and select the station
using the .m/,/ button or PRESET button in step
1
.
A station cannot be selected after you press the REC button in
4
step
.
Select the mode of track number assignment using the
MANUAL/AUTO REC button.
When the MANUAL/AUTO REC button is pressed once, the
current mode is displayed. Press the MANUAL/AUTO REC button
repeatedly to select any other mode.
REC button of the remote control unit. (The MANUAL/AUTO REC
button on the main unit will work as the PRESET button in the
tuner mode.)
Track numbers are not given automatically.
Use the TRACK INCREMENT button to divide tracks.
MANUAL is recommended for recording an analog source such
as a record.
The settings will be reset to "Manual" when the unit is turned off.
The unit will automatically insert a track division in the recorded
material when the sound level has dropped below the threshold
for more than 2 seconds, and sound has re-started.
"–20db" takes a louder signal to trigger the track increment.
"–40db" means that a relatively quiet signal will trigger the track
increment. "–40db" is suitable for recording a noiseless source
such as a CD.
When recording from a source with a lot of unwanted noise or
an analog source in auto track setting, more track numbers may
be assigned than actual tracks recorded. In this case, choose
"Manual" setting and press the TRACK INCREMENT button to
assign the track numbers as you wish.
25
Publicidad
