Publicidad
FIG. 4A
4. Attach the Left Side Panel (A) to the Bottom Shelf (C) sliding the Rafix Bolts (I) into the Rafix
Cams (H). Tighten the cams. Repeat and attach Right Side Panel (B) to Bottom Shelf (C). See
FIGURE 4A.
Slide the Top (D) into place over the Left and Right Panels. Tighten the Rafix Cams (H). Attach the
Base (E) in place and also tighten the cams. See FIGURE 4B.
K
x 20
FIG. 5A
FIG. 5C
5. With the unit laying face down on a protective surface, measure from top left to bottom right (
and from bottom left to top right (
longer, tap bottom of Left Side Panel (A) until measurements are equal. If line (
bottom of Right Side Panel (B). See FIGURE 5A.
Connect the two Backs (F) together using the Plastic H-Channel (J). See FIGURE 5B & 5C.
Attach the Backs to the unit using Screws (K). Make sure the bottom edge of the back is flush with
the bottom edge of bottom shelf and equal distance from the sides.
FIG. 4B
K K
FIG. 5B
). Measurements should be equal. If the line (
K
K
K
K K
K
K
F
K
K
K
K
K
J
K
K
K
F
K
K
)
) is
) is longer, tap
223W/224W — Page 5
Publicidad
