Whittier Wood Products 219W Instrucciones Para Armar

Assembly Instructions
220W
Standard Alder
Raised Panel
2-Door Kit
228W
Standard
Glass
2-Door Kit
Congratulations!
This fine piece of furniture will make a handsome
addition to your home. For the best results, start by
reading both the Assembly Instructions and
Finishing Hints before you begin your project.
For normal household use only.
recommended for commercial use.
219W
Standard
Reeded Glass
2-Door Kit
227W
Standard
Alder
2-Door Kit
P.O. Box 2827
Eugene, OR 97402 USA
Service Policy:
We will replace any parts which
are defective, missing or damaged during assembly.
Please contact Whittier Wood Products customer
service department directly (by phone, fax, mail or
email) for replacement parts.
Hours:
Our friendly customer service staff can
be reached Monday-Friday 7:00 a.m. to 5:00 p.m.
(Pacific Time). A message can be left 24 hours a
day, 7 days a week.
To Order:
Provide the complete furniture model
number, part letter, production code, quantity
needed, reason for replacement and your full name
and address along with a telephone number in case
we need to contact you.
Parts ship from our Eugene, Oregon factory within
1 or 2 business days from the time we receive
the request. Please allow 5-10 business days for
delivery.
Outside U.S. or Canada: 541-687-0213 Outside U.S. or Canada: 541-687-0213
Fax: 541-687-2060 • Email: info@whittierwood.com Fax: 541-687-2060 • Email: info@whittierwood.com
Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A. Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
Read both the Assembly Instructions and Finishing
Hints completely before beginning.
Store the parts: 1) in their box; 2) in a dry place; 3) in
temperatures ranging from 40° to 90°. (Not on a cold,
possibly damp, cement floor.)
Due to the fact that more than one source of hardwood
is used in this door kit, we recommend testing your stain
and/or top coat for desired color prior to attaching the
doors.
A sample chip for each source of hardwood found in
this kit has been provided for this reason. The sample chip
for the veneer fl at panel is stamped "BACK" to indicate
how the panel is positioned in the door frame. Test your
choice of stain and/or top coat on the front side.
Pay special attention to the veneer that is used in the
fl at panel of each door. This panel may require more than
one coat of stain to match the door frame. If you are using
only a clear top coat to create a natural fi nished look, you
may need to use a natural color stain on the door panel
to match the color of the door frame.
Production Code:
Rev. 6/05