Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610957373 10-08:BM_2610957373 10-08.qxp 1/6/12 1:08 PM Page 8
Use only the nails meeting the criteria
WARNING
listed in the "Specification" section of this
manual. Nails not identified for use with this tool can cause
the tool to malfunction and result in the risk of injury and/or
tool damage.
3. Pull the nail follower a second time to release latch, and
carefully allow the feeder to slide forward until it makes
contact with the nails - FIG 6.
Ensure that the head of the tail nail is set under the nail
stopper of the nail follower - FIG 7.
Watch for pinch points with the follower.
WARNING
Never place any part of your body in a
pinch point area. When loading nails consider where your
hand is located. If it is within a pinch point, strongly consider
an alternative position. Injuries occur when hands or fingers
are between moving and stationary parts during the pinching
movement.
Connecting Air Supply
Never use oxygen or other bottled gases
WARNING
as a power source. Explosion may occur.
Combustible gases and other bottled gases are dangerous
and may cause the tool to explode.
Never connect the tool to an air source
WARNING
that is capable of producing air pressure
exceeding 200 PSI. Excessive pressure can cause
abnormal operation or cause the tool to burst, resulting in
personal injury.
Use only clean, dry, regulated compressed air within the
pressure range as marked on the tool. The correct pressure
is the lowest pressure that will do the job.
Before connecting the tool to the air supply, check the air
compressor regulator gauge to be sure it is functioning
properly, and that the air pressure is within the operational
range of the tool, 60-120 psi.
Do not exceed maximum recommended
WARNING
air pressure marked on the tool. Verify
prior to using the tool that the air source has been adjusted
within the rated air-pressure range. Be sure the air pressure
gauge is operating properly and check it at least twice a day.
Tools operated in excess of their maximum pressure rating
may operate abnormally or burst resulting in personal injury
To connect the tool to the compressor only use pneumatic air
hoses that meet the following criteria:
• Minimum hose pressure rating, 200 psi
• Minimum hose inner diameter, 3/8 in.
• Maximum hose length, 100 ft.
To connect the air supply:
1. Snap the air hose onto the quick connector - FIG 8.
2. Check for air leakage. If leakage is noted, cease using the
tool immediately and contact your BOSCH service center.
3. Be sure the air pressure gauge is operating properly and
check it at least twice a day.
Operation
Tail
Nail
FIG. 7
FIG. 8
8
FIG. 6
Nail
Stopper
Publicidad
