Publicidad
Idiomas disponibles
Idiomas disponibles
1. MODE button: selects the setting mode.
2. RADIO button: press this button to turn the radio on or off and to snooze the
alarm
3. VOL. button: press this button to control the volume. Press once, and then
press on UP or DOWN to change the volume.
4. LCD screen
5. Battery compartment (at the bottom of the unit)
6. Night-light rubber feet
7. DOWN button: press this button to change the radio frequency or to turn the
volume down.
8. UP button: press this button to change the radio frequency or to turn the
volume up.
9. Captain America button
10. Speaker
11. Projector
12. PROJECT button: projects the time onto the ceiling.
Your Avengers Radio Alarm Clock Projector works with 4 x 1.5V
AA / LR6 type batteries (not included).
When you use the RP500FZ for the first time:
1. Using a screwdriver, open the battery compartment
cover located at the bottom of the unit.
2. Install the 4 x AA/LR6 1.5V
observing the polarity markings inside the battery
compartment.
3. Close the battery compartment and tighten the screw.
IMPORTANT NOTE: For better performance, it is recommended to use alkaline
batteries with this product.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries
are to be removed from the product before being charged. Rechargeable
batteries are only to be charged under adult supervision. Different types of
batteries or new and used batteries are not to be mixed. Only batteries of the
same or equivalent type as recommended are to be used. Batteries are to be
inserted with the correct polarity. Exhausted batteries are to be removed from
the product. The supply terminals are not to be short circuited. Do not throw
batteries into a fire. Remove the batteries if you are not going to use the
product for a long period of time. Battery shall not be exposed to excessive
heat such as sunshine, fire or the like.
Product description
Battery information
batteries (not included)
8
1.5V AA OR LR6
1.5V AA OR LR6
1.5V AA OR LR6
1.5V AA OR LR6
Publicidad
