STERWINS 1300 JET AUTO 5I-3 Manual De Instrucciones página 206

FR Interface :
ES
PT
IT
EL
5. TRANSPORTATION
PL
5.1 TRANSPORT THE MACHINE
RU
KZ
Protect the product from any heavy impact or strong vibrations which may occur during transportation
UA
in vehicles. If you want to transport the appliance on a vehicle secure it from slipping or vibrating.
Secure the product to prevent it from slipping or falling over.
RO
6. WINTERING
EN
Illustration 6.1 to 6.3
Switch off and empty the pump.
Follow all instructions given on chapter storage below.
7. STORAGE
7.1 STORE THE MACHINE
The instructions mentioned in the maintenance section must be carried out before any storage.
Illustration 6.1 to 6.3
• Completely drain the pump, allow it to dry and put back the two connector caps.
• Clean the product, filters and accessories
• Store the unit and its accessories in a frost-free place.
• The unit should always be stored in a clean, dry, ventilated place out of the reach of children. Ideally, the
temperature of the room in which the device is stored should be between 4 and 24°C.
• We recommend that you store the unit in an upright position, in its original package.
• Power On : If lit, the pressure control unit has been powered and is ready for
operation. The pump is not running.
• Pump On : If lit, the pump is operating. A line of the discharged liquid is
opened.
• Failure : If lit, the pressure control has detected a fault. In that case, please refer
to "Troubleshooting" chapter.
• Restart : To restart the pump after resolving a failure, reset the pressure control
unit by pressing this button.
CAUTION In order to prevent accidents or injuries,
keep in mind the weight of the appliance during transport
(see Technical Data).
206