Publicidad
Idiomas disponibles
Idiomas disponibles
Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
GROUNDING INSTRUCTIONS
This appliance must be grounded. Grounding
reduces the risk of electrical shock by providing an
escape wire for the electrical current.
This appliance has a cord that has a grounding
wire with a 3-prong plug. The power cord must be
plugged into an outlet that is properly grounded.
If the outlet is a 2-prong wall outlet, it must be
replaced with a properly grounded 3-prong wall
outlet. The serial rating plate indicates the voltage
and frequency the appliance is designed for.
WARNING - Improper use of the grounding
plug can result in a risk of electric shock.
Consult a qualifi ed electrician or service agent
if the grounding instructions are not completely
understood, or if doubt exists as to whether the
appliance is properly grounded.
Do not connect your appliance to extension
cords or together with another appliance in the
same wall outlet. Do not splice the power cord.
Do not under any circumstances cut or remove the
third ground prong from the power cord. Do not
use extension cords or ungrounded (two prongs)
adapters.
If the power supply cord is damaged, it must be
replaced by the manufacturer, its service agent or
similar qualifi ed person in order to avoid hazard.
LOCATION
• Two people should be used when moving the
• Place the appliance on a fl oor that is strong
• Do not place the appliance in direct sunlight or
• For optimum temperature performance, it is
• Do not use the appliance near water, for
• Before connecting the appliance to a power
• Allow 12.7 cm (5 inches) of space between the
• This appliance is intended for free-standing
• This appliance is not designed for outside
SAVE THESE INSTRUCTIONS!
appliance.
enough to support it when it is fully loaded.
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
recommended that this appliance be at least
30% full at all times. If the appliance is not
30% full, it is recommended to add some water
bottles or freezer packs to ensure temperature
stability.
example in a wet basement or near a sink.
source, let it stand upright for approximately 6
hours to avoid damage to internal components.
back of the appliance and the wall. Allow 5 cm
(2 inches) of space between the sides and top of
the appliance and all adjacent walls.
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
installation, including anywhere that is not
temperature controlled (garages, porches,
vehicles, etc.).
Publicidad
