7
8
9
7. Install stator to the rear of the handle halve. Place stator wires in handle halve cavity,
behind on-off switch in the following order from bottom to top: gray, purple and black.
Be sure stator is firmly and squarely in handle cavity and that stator wires are pushed
completely down below the top edge of handle.
8. Check that all electrical and mechanical components are properly in place in handle
halve. Be sure there are no interferences creating pinched wires.
9. Install right handle halve (cover) over left handle halve (support). Check for the proper
functionality of switch and shuttle. Secure handle halves together with five M3 x 16mm
screws (41) and two M3 x 38mm screws (42).
Carefully install rotor/back cap assembly into stator and onto the rear of tool (see
illustration). Secure with four M3 x 16mm screws.